| A close range pulley rig using light tackle to present smaller baits (eg. single lug or a piece of squid) on a long flowing snood. Sinker not included.
To Make this Rig
For the rig body, you will need;
1 x Genie Link Clip
2 x Genie 3mm Bead
1 x Genie 45lb Snood Swivel
1 x Genie Bent Rig Clip
1 x Red pulley clip spacer
2 x Genie Mini-Crimp
1 x 4mm bead
1 x 6mm of Genie 1.5mm silicone tubing
1 x Genie Rig Clip
1 x Genie 80lb Main Line Swivel
1 x approx. 1130mm length 60lb
main line (for 830mm body)
You will also need;
1 x 1230mm snood
The Rig Body
1. Clip the 45lb snood swivel onto the bent rig clip.
2. Tie on the 80lb main line swivel and thread on the rest of the components in this order;
| |
crimp
4mm power bead
Rig Clip
sliding stop knot
4mm bead.
|
eye of bent Rig Clip
Crimp
red spacer
free eye of 45lb swivel
3mm bead
|
|
3. Tie on the top Genie Link Clip, ensuring the rig is approx. 830mm.
4. Hang the rig by the top Genie Link Clip from a peg and clip a sinker onto the free running Genie Rig Clip.
5. Take the crimp below the red spacer and push up the main line until the pulley clip swivel is about 10mm from the top swivel and secure the crimp. This should leave the bent Genie rig clip hanging from the swivel.
6. Olace the snood (about 1/2 way along its length) over the Genie pulley clip locate the hool into the bottom Genie Rig Clip.
7. Push the silicone stop knot and 4mm bead up the line to approx. 100mm below the Genie Pulley Clip assembly.
8. Push the remaining crimp up to approx. 30mm from the main line swivel and secure.
|