Shown with system 100+ 150g flat back sinker - available separately
| Line |
830mm |
60lb |
| Main Snood |
700mm |
25lb |
| Hook |
Viking |
# 2/0 |
| Available as: |
Genie® Ready Rig |
| |
Genie® Ready Rig Ultra! |
|
This rig had been designed with a free running snood, allowing the fish to bolt and then be pulled up sharp when it comes up against the weight, giving good bite indication. As a distance rig, it is suitable for most fishing and particularly good for cod.
Sinker not included.
To Make this Rig
For the rig body, you will need;
2 x Genie Link Clips
1 x Breakaway Impact Shield
1 x Genie 4mm Power Beads
1 x Genie 4mm Beads
3 x Genie Mini-Crimps
3 x Genie 3mm Beads
1 x Genie SRT Spring
1 x Genie 45lb Snood Swivel
1 x Genie Bemt Rig Clip
1 x Red pullry clip spacer
1 x 6mm length of Genie 1.5mm silicone tubing
1 x
approx. 1130mm length 60lb
main line (for 830mm body)
You will also need;
1 x 700mm snood
The Rig Body
1. Clip the 45lb snood swivel onto the bent rig clip.
2. Tie on the lower Genie Link Clip and thread on the rest of the components in this order.
| |
|
sliding stop knot |
4mm power bead |
4mm bead |
crimp |
crimp |
3mm bead |
eye of bent Rig Clip |
snood swivel |
crimp |
| |
3mm bead |
red spacer |
| |
spring |
free eye of 45lb swivel |
| |
crimp |
3mm bead |
3. Tie on the Genie Link Clip, ensuring the line is approx. 830mm in length.
4. Hang the rig from a peg by the free running Genie Link Clip and attach a sinker to the lower Genie Link Clip.
5. Position the Breakaway Impact Shield just above the lower knot and secure the first crimp immediately above the 4mm release bead.
6. Position in top crimp (below the red spacer) approx. 70mm below the top knot and secure (This should leave the bent Genie rig clip hanging from the swivel.)
7. Clip the snood onto the snood swivel and locate the hook in the Breakaway Impact Shield and lay the top end of the line over the bent rig clip.
8. Hold the sinker down firmly, take the crimp above the spring and push it down until the spring is compressed to 3/4 its length and secure.
9. Finally position the sliding stop knot and 4mm release bead approx. 10mm below the pulley clip.
|